PCIe 4.0 x1 180-Degree Down-Angle Riser Cable
This passive PCIe riser extends a compatible host slot to an endpoint while preserving the stated lane width and connector orientation.
Compatibility checks before ordering
- Host slot, endpoint and riser must support the same PCIe generation and lane width.
- Confirm the connector direction, bend orientation, cable length and available chassis clearance.
- Signal margin depends on the complete channel; validate the final system at the target PCIe generation.
Integration notes
Validate the complete PCIe channel rather than the cable alone. Motherboard routing, slot placement, connector transitions, endpoint PCB design and cable length all affect signal margin. If link training falls back to a lower speed or lane width, test with a shorter cable and a known-good endpoint. Secure the assembly so vibration, sharp bends or side loading do not stress the connectors. The stated angle describes the cable-exit direction and should be checked against the installation drawing.
For a compatibility review and quotation, provide the host model, endpoint model, required length, connector orientation and quantity on the contact page.